Oracle Linux 8 – Common Problem 015 – Diagnosis and Fix

📖 ~3 min read

Table of contents

1. Symptom & Impact
2. Environment & Reproduction
3. Root Cause Analysis
4. Quick Triage
5. Step-by-Step Diagnosis
6. Solution – Primary Fix
7. Solution – Alternative Approaches
8. Verification & Acceptance Criteria
9. Rollback Plan
10. Prevention & Hardening
11. Related Errors & Cross-Refs
12. References & Further Reading

Symptom & Impact

On Oracle Linux 8 hosts affected by problem 015, administrators observe issues related to: nftables ruleset reset on reboot despite firewalld persistence. Operators see failed `systemctl status` output, abnormal entries in `journalctl -xe`, and degraded service availability. Impact ranges from individual service outages to wider production incidents depending on the host role and how widely the affected component is used.

Environment & Reproduction

Reproduction targets Oracle Linux 8 (RHEL 8 family) running either the Red Hat Compatible Kernel or the Unbreakable Enterprise Kernel. Confirm release with `cat /etc/oracle-release` and kernel with `uname -r`. Trigger the workflow that exposes `nftables ruleset reset on reboot despite firewalld persistence` while collecting `journalctl -b` and `dnf history` output for correlation.

Root Cause Analysis

Root cause for `nftables ruleset reset on reboot despite firewalld persistence` typically traces to a combination of package state managed by dnf, unit configuration under /etc/systemd/system, firewalld zone bindings, and SELinux booleans or file contexts. Correlate `journalctl –since` timestamps with `dnf history` and `ausearch -m AVC` entries to isolate the originating change.

Quick Triage

Quick triage for problem 015: run `systemctl status `, `journalctl -u -n 200`, `firewall-cmd –list-all`, and `getenforce`. Run `dnf check` and `rpm -Va` for package drift. If SELinux is enforcing, capture `ausearch -m AVC -ts recent` to surface denials linked to `nftables ruleset reset on reboot despite firewalld persistence`.

Step-by-Step Diagnosis

1) Confirm the symptom with `systemctl –failed`. 2) Inspect logs: `journalctl -xe` and unit-specific `journalctl -u `. 3) Validate firewall: `firewall-cmd –list-all-zones`. 4) Check SELinux denials: `ausearch -m AVC,USER_AVC -ts today`. 5) Verify package integrity with `dnf check` and `rpm -V `. 6) Correlate findings against `dnf history` and `/var/log/dnf.log` to pin the change that introduced `nftables ruleset reset on reboot despite firewalld persistence`.

Solution – Primary Fix

Primary fix for `nftables ruleset reset on reboot despite firewalld persistence`: apply the corrective dnf transaction, reload the affected systemd unit, and reconcile firewalld and SELinux state. Typical commands: `sudo dnf -y reinstall `, `sudo systemctl daemon-reload`, `sudo systemctl restart `, `sudo firewall-cmd –reload`, and `sudo restorecon -Rv `. Validate immediately with `systemctl is-active `.

Solution – Alternative Approaches

Alternatives include rolling back the offending transaction with `sudo dnf history undo `, switching the firewall backend between nftables and iptables via `/etc/firewalld/firewalld.conf`, or temporarily setting SELinux to permissive with `setenforce 0` to confirm policy is the cause before authoring a custom module with `audit2allow`.

Verification & Acceptance Criteria

Acceptance: `systemctl is-active ` returns active, `journalctl -u –since ‘5 minutes ago’` shows no errors, `firewall-cmd –list-services` includes the required services, `getenforce` reports the intended mode, and the original reproduction steps for `nftables ruleset reset on reboot despite firewalld persistence` no longer trigger the failure across two consecutive runs.

Rollback Plan

Rollback: capture state with `dnf history list` and `rpm -qa > /root/rpm-pre.txt` before any change. To revert, run `sudo dnf history undo `, restore `/etc` backups, and reload `systemctl daemon-reload`. For SELinux modules, remove with `sudo semodule -r `. Reboot if the kernel or initramfs was changed and re-verify symptoms.

Prevention & Hardening

Prevent recurrence with `dnf-automatic` for security updates, `needs-restarting -r` checks, immutable systemd drop-ins under `/etc/systemd/system/.d/`, version-locked firewalld zones, and audit rules in `/etc/audit/rules.d/`. Apply CIS Oracle Linux 8 hardening and monitor file integrity with `aide –check`.

Related Errors & Cross-Refs

Related issues commonly surface alongside `nftables ruleset reset on reboot despite firewalld persistence`: dnf transaction lock contention, systemd unit ordering cycles, SELinux AVC bursts, firewalld zone drift, and kernel taint flags shown by `cat /proc/sys/kernel/tainted`. See sibling common problem articles in this Oracle Linux 8 series for adjacent failure modes.

Related tutorial: View the step-by-step tutorial for oracle-linux-8.

View all oracle-linux-8 tutorials on the Tutorials Hub →

Browse all common problems & solutions on the Tutorials Hub.

References & Further Reading

References: Oracle Linux 8 Administrators Guide, Red Hat Enterprise Linux 8 documentation, `man dnf`, `man systemctl`, `man firewall-cmd`, `man semanage`, `man journalctl`, and the Oracle Linux yum server changelog. Review `/usr/share/doc/` package documentation for the components implicated in `nftables ruleset reset on reboot despite firewalld persistence`.